The engraving machine is a precision CNC machine, so you should have a deep understanding of all aspects of it before using it. If there are some common problems, how can we solve them? Today, Guangzhou Sanwei Electromechanical will tell you:
1. The spindle motor of the engraving machine does not rotate or reverse
(1) Whether the signal line of the inverter is reversed;
(2) Check the setting of the parameters of the inverter.
2. When the software is opened, the computer prompts “Failed to open the card, please check the card”
(1) Check if the driver of the board is installed or replace the card with a PCI slot;
(2) Reinstall the two data cables to check if there is any broken needle;
(3) There is a problem with the board, and the board is replaced.
3. When the X-axis is walking a certain section, the Z-axis does not raise the knife.
(1) Check if the Z-axis motor is running normally, the power and the current of the drive or its own fault;
(2) Check if the Z-axis motor line has poor contact or intermediate disconnection.
4. Misalignment or incorrect size when engraving
(1) Check if the path of the engraving software is correct or not;
Check the clearance of the screw and whether the fastening screws of the polished rod are loose;
(2) Check that the software parameters are set correctly.
There is a port status on the computer software. You can check the status of each port. Generally, the problem will be reported here. Therefore, if you find that the device is faulty, please check whether the port status is normal. Can help the group quickly troubleshoot the problem.
1. The spindle motor of the engraving machine does not rotate or reverse
(1) Whether the signal line of the inverter is reversed;
(2) Check the setting of the parameters of the inverter.
2. When the software is opened, the computer prompts “Failed to open the card, please check the card”
(1) Check if the driver of the board is installed or replace the card with a PCI slot;
(2) Reinstall the two data cables to check if there is any broken needle;
(3) There is a problem with the board, and the board is replaced.
3. When the X-axis is walking a certain section, the Z-axis does not raise the knife.
(1) Check if the Z-axis motor is running normally, the power and the current of the drive or its own fault;
(2) Check if the Z-axis motor line has poor contact or intermediate disconnection.
4. Misalignment or incorrect size when engraving
(1) Check if the path of the engraving software is correct or not;
Check the clearance of the screw and whether the fastening screws of the polished rod are loose;
(2) Check that the software parameters are set correctly.
There is a port status on the computer software. You can check the status of each port. Generally, the problem will be reported here. Therefore, if you find that the device is faulty, please check whether the port status is normal. Can help the group quickly troubleshoot the problem.